GM Small Block Compatible 400 c.i. Engine and TKX Manual Transmission - 500 Horsepower - Standard Edition Builder Series - Polished Pulley Kit - Carbureted

**This package�features a carbureted engine. EFI�engine pictured as rep image.

Description:

• Horsepower & Torque: 500 Horsepower / 510 FT. LBS. Torque
• Compression Ratio: 10.3:1
• BluePrint Engines Aluminum Heads
• BluePrint Engines Hydraulic Roller Cam
• BluePrint Engines Forged Crank
• BluePrint Engines Forged Pistons
  

Block:

• BluePrint Engines High Strength Cast Iron Block
  
• Drilled and Tapped for Clutch Linkage
• Mech Fuel Pump Provision: Yes
• Passenger Side Dipstick
• 1-Piece Rear Main Seal
• 4-Bolt Main
• 4.125" Bore
  

Rotating Assembly:

• BluePrint Forged Crankshaft
• 3.750" Stroke
• Forged I Beam 5.700" Connecting Rods w/ 150,000 PSI Bolts
• Forged Pistons
• Internally Balanced Front - Externally Balanced Rear�

Cylinder Heads:

• BluePrint Aluminum Cylinder Heads - HP8103
• 64cc Chamber
• 2.08" Intake / 1.60" Exhaust Valves
• 220cc Intake / 67cc Exhaust Runners

Cam Specs:

• Hydraulic Roller
• .555 Intake / .576 Exhaust Lift
• 236 Intake / 242 Exhaust Duration
• @ .050-110 Degree Lobe Separation

Ignition Timing:

• 10-16掳 Initial and Total Timing 32-34掳 at 3500 RPM

Also Includes:

• Polished Front Accessory Drive with Water Pump, A/C Compressor, Alternator, and Power Steering Pump - BPP350FDACPS4
• Holley 850cfm Double Pumper Carburetor w/ Manual Choke
• Intake Manifold Dual Plane Satin Aluminum - BPP350VINT
  
• Pro Series Ready Run Distributor -�BPP3503BK
• Thermostat Housing - BPP10108470
  
• Mechanical Fuel Pump -�BPP61073
• Thermostat - BPP180TS
  
• Spark Plugs - BPP7938
• Plug Wire Separators
• Spark Plug Wires
• Valve Covers
• Timing Cover
  
• Oil Filter
• Oil Pan
  

Assembled with Complete TKX Transmission Package:

• Mcleod Super Street Pro Single Disk Clutch
• Hydraulic Throw Out Bearing
• Bell Housing
• Billet Flywheel
• Starter
• First Gear Ratio:�2.87:1
• Second Gear Ratio:�1.89:1
• Third Gear Ratio:�1.28:1
• Fourth Gear Ratio:�1.00:1
• Fifth Gear Ratio:�0.81:1

Notes:

• The front accessory drive on this engine fits many vehicles, however it is the customer responsibility�to accurately�measure and confirm fitment.� Note this is a low-profile design, but things such as power steering hoses, alternator wiring, and additional fittings/fabrication may be required on some vehicles.
  
• The performance aluminum cylinder heads on this engine feature a .500 raised port vs OEM.
• Package Ships assembled as pictured.�
• IF THIS IS BEING ORDERED FOR A FACTORY FIVE VEHICLE,�STOP�AND CALL US AT�1-800-483-4263 FOR PROPER FITMENT OR VISIT�FACTORYFIVEENGINES.COM